Product Application

Cut the top plastic of the cartridge and attach the plastic nozzle.Apply pressure and form vertical beads of the adhesive, at intervals of few centimeters, onto your prepared substrate.

Press or tap part to be bonded well onto the adhesive to ensure good adhesion.
Adhesive layer thickness depending on surface evenness 0.1 to 0.3 cm. A 0.3 cm thickness adhesive layer must be limited to avoid sliding of the bonded part.

If necessary, use adhesive tapes, wedges or props to hold the assembled elements together in case of heavier elements for the first 48 hours of curing.

An incorrectly positioned element can be easily readjusted during 5 minutes after application. Apply pressure again.